Starting Enrichment - 5-Cylinder Models
- Connect test harness between differential pressure regulator and vehicle harness. Connect multimeter to test harness. Disconnect wiring from coolant temperature sensor. Plug jumper end of Test Resistor (VW 1490 ) into harness connector of temperature sensor. Activate starter for 3 seconds.
- Current reading should be more than 70 mA for first 1.5 seconds of starter operation. If not, check for open circuit between terminal No. 24 on ECU connector and terminal No. 15a on starter. If starter circuit is okay, check between terminals No. 2 and 21 on ECU connector. If wiring is okay, replace ECU.