LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 1987 >> 5000 CS, Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Test 15 >> All Models
April 5, 2026: LEMON Manuals is launched! Read the announcement.

All Models

  1. Item Being Tested - Hydraulic Modulator Diode & ABS Indicator Light Place ABS tester in program switch position No. 15. Voltage reading on ABS tester should be 2.5-8.5 volts and ABS indicator light must dim slightly.
  2. If indicator light does not come on or if voltage reading is incorrect, check indicator light and corresponding power supply wire. To do so, turn ignition off.
  3. Use ohmmeter to check continuity and contact resistance between terminal No. 10 in plug for hydraulic modulator and terminal No. 29 in plug for ABS control unit. If necessary, repair wiring harness to restore continuity or eliminate contact resistance. After repairs, go to next step.
  4. Use ohmmeter to measure continuity between terminals No. 10 and 12 in socket of hydraulic modulator. Note continuity on ohmmeter, and then reverse leads.
  5. Ohmmeter must indicate continuity in one direction only. Replace hydraulic modulator if results are incorrect. If okay, turn ignition on and remove solenoid valve relay. If indicator light comes on, replace hydraulic modulator.
scientia non olet · About LEMON Manuals