LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 1987 >> 5000 CS, Standard >> Repair and Diagnosis >> Engine Performance >> System >> BOSCH Cis-E System >> Testing >> Electrical Components >> Idle Speed Stabilization System
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Idle Speed Stabilization System

  1. Engine oil temperature must be at 176°F (80°C) minimum. Ignition timing point is 4-8 degrees BTDC. A/C must be off. Connect Dwell Meter (VW 1367 ) using Adapter Cable (US 1112 ). Set "%" button on dwell meter and check duty cycle.
  2. Reading should be 26-30% with oxygen sensor connected. Idle speed should be 800-900 RPM. If not, adjust duty cycle.
  3. If reading shows 33% or 40%, ensure A/C is switched off. If A/C is off, check idle throttle switch function. Check for open circuit between idle switch and ECU connector.
  4. If reading is fluctuating between 20-25%, check for open circuit in RPM signal from ignition ECU. If reading is steady 25%, and idle speed is high. Check for air leaks in throttle body. If no leaks are found, check for open circuit between ECU and idle stabilizer control valve. If circuit is correct, replace idle stabilization valve.
  5. Turn A/C on. Idle speed should increase by 100 RPM. If not, check for open circuit between A/C switch on dash and terminals No. 6 and 16 on ECU connector. Check for RPM increase of 100 RPM when A/C compressor cycles off.
  6. If idle speed goes over 1000 RPM when A/C compressor switches off, check compressor signal wire to ECU. Wire should go to ECU connector terminal No. 19. Ensure it is connected to the correct terminal and not terminal No. 16. Check wiring diagram and correct.
scientia non olet · About LEMON Manuals