LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 1991 >> 200 Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Testing >> Fuel System (2.8L V6) >> Fuel Control (2.8L) >> Oxygen (O2) Sensor Control (2.8L)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Oxygen (O2) Sensor Control (2.8L)

  1. Disconnect oxygen sensor connector. See COMPONENT LOCATIONS  . Measure resistance between engine ground and oxygen sensor connector terminal (component side of connector). If resistance is not infinite, replace oxygen sensor.
  2. If resistance is infinite, set voltmeter on 2 volt DC scale. Turn ignition on. Measure voltage between engine ground and oxygen sensor connector terminal (component side of connector). If 350-450 millivolts are present, oxygen sensor is okay. If 350-450 millivolts are not present, check wiring. If wiring is okay, replace ECU.
scientia non olet · About LEMON Manuals