LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 1991 >> 200 Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Fuel Control (2.2L) >> Deceleration Fuel Shutoff Check (M/T Only)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Deceleration Fuel Shutoff Check (M/T Only)

  1. Reconnect wiring to temperature sensor. Ensure oil temperature is at least 120°F (50°C). Start engine and operate briefly at 2000 RPM. Release throttle.
  2. If intake boot does not contract, disconnect harness plug from deceleration fuel shutoff valve. Attach a voltmeter between harness terminals. Start engine and operate briefly at 2000 RPM. Release throttle.
  3. If battery voltage is present and vacuum hose is okay, replace deceleration fuel shutoff valve. If battery voltage is not present, check operation and adjustment of throttle switch at idle. If okay, check for open circuit between throttle switch and ECU.
    NOTE: Deceleration fuel shutoff valve terminal identifications are located on connector.
  4. If circuit is okay, connect Adapter Cable (US 1112) to Green test lead of OXS system test connector (Blue/Black wire). Connect Dwell Meter (VW 1367) to vehicle. Set the "%" button on dwell meter. Disconnect harness connector from deceleration fuel shutoff valve.
  5. Using a jumper wire, connect harness side terminal No. 2 of deceleration fuel shutoff valve to ground. If dwell meter does not indicate 40%, turn ignition off. Disconnect ECU harness connector.
  6. Check resistance in wire between ECU terminal No. 4 and deceleration fuel shutoff valve terminal No. 2. See Figure for ECU terminal identifications. Resistance should be less than .2 ohm. If resistance is not less than .2 ohm, check for open circuit in wire. If wire is okay, replace ECU.
NOTE: Throttle switch terminal identifications are located on connector.
scientia non olet · About LEMON Manuals