LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 1994 >> Cabriolet >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Fuel System >> Fuel Control >> Fuel Injectors
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Injectors

  1. Disconnect fuel injector connector. Measure resistance across fuel injector connector terminals. If resistance is not 15-17 ohms, replace fuel injector. If resistance is 15-17 ohms, connect LED Tester (US 1115) between engine ground and fuel injector connector terminal No. 2. See Fig 1 .
  2. Operate starter for several seconds. If LED comes on, go to next step. If LED does not come on, check fuel pump relay, circuit breaker and wiring. See FUEL DELIVERY. If fuel pump relay, circuit breaker and wiring are okay, connect LED tester between battery positive source and fuel injector connector terminal No. 1.
  3. Operate starter for several seconds (engine may start). If LED flashes, fuel injector system is okay. If LED does not flash, check for faulty wiring. If wiring is okay, replace ECM. See the ELECTRICAL COMPONENT LOCATIONS  table at beginning of article.
Fig 1: Identifying Terminals Of Typical 2-Pin Connector
G94344Courtesy of AUDI OF AMERICA, INC.
scientia non olet · About LEMON Manuals