LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 1996 >> Cabriolet >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Circuit Tests >> DTC P0452/16836 - EVAP System Pressure Sensor Low Input
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P0452/16836 - EVAP System Pressure Sensor Low Input

NOTE: DTC is set soon after engine start if EVAP differential pressure sensor signal is less than .1 volt for more than 2 seconds with EVAP emissions valve duty cycle more than 91 percent (100 percent equals valve closed).
  1. Inspect EVAP canister differential pressure sensor connector for looseness and/or corrosion. EVAP canister differential pressure sensor is located in right front corner of engine compartment. Repair sensor connector as necessary. If sensor connector was not repaired, go to next step. If sensor connector was repaired, erase DTC memory and test drive vehicle.
  2. Inspect EVAP system hoses between EVAP canister and throttle body. Repair hoses as necessary. If hoses were not repaired, go to next step. If hoses were repaired, erase DTC memory and test drive vehicle.
  3. Disconnect EVAP canister differential pressure sensor electrical connector. EVAP canister differential pressure sensor is located in right front corner of engine compartment. Turn ignition on. Using DVOM, check voltage on EVAP differential pressure sensor harness connector between terminals No. 1 (ground) and 3 (B+). Voltage should be approximately 5 volts. If voltage is within specification, go to step 7). If voltage is not within specification, go to next step.
  4. Turn ignition off. Disconnect Powertrain Control Module (PCM) connectors. Connect VAG 1598/19 test box to PCM wiring harness. Terminal assignments of test box are identical to PCM connectors "A", "B", "C", "D" and "E".
  5. Using DVOM, check for continuity between EVAP differential pressure sensor harness connector terminal No. 1 and test box socket C2. If continuity is present, go to next step. If continuity is not present, repair open or short in wiring harness as necessary. Erase DTC memory and test drive vehicle. If an open or short circuit cannot be located, replace faulty PCM. Code new PCM and test drive vehicle. See PCM CODING  in this article.
  6. Using DVOM, check for continuity between EVAP differential pressure sensor harness connector terminal No. 3 and test box socket C6. If continuity is present, go to next step. If continuity is not present, repair open or short in wiring harness as necessary. Erase DTC memory and test drive vehicle. If an open or short circuit cannot be located, replace faulty PCM. Code new PCM and test drive vehicle. See PCM CODING in this article.
  7. Using DVOM, check for continuity between EVAP differential pressure sensor harness connector terminal No. 2 and test box socket B16. If continuity is present, circuit is okay. Replace EVAP differential pressure sensor. Erase DTC memory and test drive vehicle.
  8. If continuity is not present, repair open or short in wiring harness as necessary. Erase DTC memory and test drive vehicle. If an open or short circuit cannot be located, replace faulty PCM. Code new PCM and test drive vehicle. See PCM CODING  in this article.
scientia non olet · About LEMON Manuals