Removal & Installation
WARNING: This page is about the A6 Quattro, 2.7 D, Automatic, which is a different variant/trim than selected.
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Twin Turbocharger | 12.7 | 10.8 | C | |
| Combination Procedure: CLUTCH PILOT BEARING: Replace: | ||||
| 0.8 | C | |||
| Combination Procedure: CLUTCH PRESSURE PLATE &/OR DISC: Replace: | ||||
| 0.6 | C | |||
| Combination Procedure: CLUTCH RELEASE BEARING: Replace: | ||||
| 0.2 | C | |||
| Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Replace: | ||||
| 5 Spd Trans, Rear | 0.2 | B | ||
| Combination Procedure: FLYWHEEL: Remove & Install or Remove & Replace: | ||||
| 0.9 | C | |||
| Combination Procedure: INPUT SHAFT SEAL: Replace: | ||||
| 5 Spd Trans | 0.3 | B | ||
| Combination Procedure: TRANSMISSION ASSEMBLY: Replace: | ||||
| 0.4 | C | |||