Removal & Installation (A6)
- Remove screws from top ends of door panel. Remove corresponding power window switch. See POWER WINDOW SWITCH
. Lift door panel up to disengage retainers. Disconnect inside door handle release cable from door panel. Disconnect remaining electrical connectors from door panel. Remove door panel from vehicle.
- Unclip harness connectors from door carrier assembly. Mark position of carrier in relationship to door. Remove 4 bolts attaching door carrier assembly to door. See Figure
. Lift door carrier assembly up and out of door using care not to scratch finish.
- To remove regulator and motor assembly, go to next step. To remove motor, remove window motor mounting screws. See Figure
. Disconnect harness connector. Pry motor out of carrier assembly. To install motor, reverse removal procedure. Tighten mounting screws to 40 INCH lbs. (4.5 N.m).
- Drill out rivets attaching regulator to door carrier assembly and detach regulator. Note different sizes of pop rivets for proper installation. To install regulator and motor assembly, reverse removal procedure. Installing rivets in correct order. See Fig 1
.
Courtesy of AUDI OF AMERICA, INC.