LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 2002 >> A6 Base >> Repair and Diagnosis >> Electrical >> Charging Systems >> Generators & Regulators >> On-Vehicle Testing >> No Load Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

No Load Test

CAUTION: Battery cell caps must be bolted in tightly when charging, measuring voltage or performing load tests.
NOTE: If no load voltage is to be measured with battery installed in vehicle, first disconnect ground strap.
NOTE: Vehicle must not be started or driven with tested battery for at least 2 hours before taking measurements. During this time, DO NOT allow load or additional charge to be applied to battery.

With battery installed, and ignition switched to OFF position, check voltage between battery terminals with voltmeter. If no load voltage is 12.5 volts, or higher, battery is okay. If no load voltage is lower than 12.5, recharge battery, and repeat procedure. If battery voltage is still less than 12.5 after charging battery, replace battery.

scientia non olet · About LEMON Manuals