Throttle Valve Control Module Air Guide, Cleaning, RS6: Installing
Installation is reverse of removal, but note the following:
NOTE:
Replace the seal.
Before installing, make sure the hose connections as well as air guide pipes and hoses are free of oil and grease.
Secure all hose connections with hose clamps that match current standard production.
Before installing, spray the screw clamps with rust remover so that they can be used to secure the air guide hoses onto the connections.
It is important to maintain the installation position of the hose clamps on the air guide pipes so that there is sufficient clearance around the crash sensors. Refer to REMOVAL AND INSTALLATION .
-- After removing and installing the throttle valve control module, perform an "adaptation" in "Guided Functions".