Power Steering, Checking For Leaks And Fluid Level
NOTE:
Do not let the engine idle.
Front wheels pointing straight ahead.
Cold Fluid (approximately 68°F (20°C):
-- Remove the cap.
-- Clean the dipstick with clean cloth.
-- Screw cap on hand-tight and remove again.
NOTE:
Screw cap fully in to get an accurate fluid level reading.
-- Check oil level: The oil level must be in the -B- range.
Warm oil (approximately 176°F (80°C):
-- Remove the cap.
-- Clean the dipstick with clean cloth.
-- Screw cap on hand-tight and remove again.
NOTE:
Screw cap fully in to get an accurate fluid level reading.
-- Check oil level: Oil level must be in -A- range.
NOTE:
If fluid level is above specified range, then some fluid must be siphoned off.
Do not use extracted hydraulic oil.
WARNING:
If the fluid level is below the specified level, check the hydraulic system for leaks (repair measure). It is not sufficient just to add fluid.