Tightening Specifications
| Component | - | Nm |
|---|---|---|
| Four hydraulic unit brake lines to the brake calipers | 14 | |
| Hydraulic unit brake lines to master brake cylinder | 16 | |
-- Install the brake lines into the mounts.
-- Connect the connector to the coolant reservoir.
-- Install the coolant reservoir with attached coolant lines.
-- Fasted the coolant reservoir with attached coolant lines to the bracket.
-- Remove the Brake Pedal Actuator VAG 1869/2.
-- Refer to BRAKE SYSTEM, BLEEDING
-- Start the program in Guided Functions on the Vehicle Diagnostic Tester if the control module is replaced.
-- Perform an output diagnostic test in Guided Functions on the Vehicle Diagnostic Tester after attaching the brake lines.
CAUTION:
Make sure the brakes are working correctly before driving the vehicle.