Windshield Projection Head Up Display Control Module -J898-

CAUTION:

Danger of causing damage.

Remove only the marked screws from the windshield projection head up display control module.
The windshield projection head up display control module must be replaced if the screws are removed from the housing upper section.
The windshield projection head up display control module must be replaced if it falls down because the inner components will get damaged even though there is no damage on the outside.
Do not place any force on the housing upper section for the windshield projection head up display control module otherwise the windshield projection head up display control module will have to be replaced.

Removal

Fig 1: Identifying Windshield Projection Head Up Display Control Module, Screws And Connector

Courtesy of AUDI OF AMERICA, LLC

-- Cover the control module -3- with a soft towel.

-- Remove the windshield. Refer to WINDSHIELD, REMOVING AND INSTALLING .

-- Remove the screws -1, 2 and 5-.

-- Lift the control module slightly and disconnect the connector -4-.

-- Remove the control module.

Installation

Install in reverse order of removal, observing the following:

-- Install the control module and tighten the screws.

-- Mount the windshield and secure it - do not bond it.

-- Turn on the ignition and check the control module function.

-- Install the windshield. Refer to WINDSHIELD, REMOVING AND INSTALLING .

-- Install the upper instrument panel cover. Refer to INSTRUMENT PANEL UPPER COVER, REMOVING AND INSTALLING .

-- Install the windshield projection control module cover. Refer to OVERVIEW - INSTRUMENT PANEL, WINDSHIELD PROJECTION (HEAD UP DISPLAY) .