2.0L - MULTIPORT Fuel Injection - Engine Code(S): CPMA

• 24 MULTIPORT Fuel Injection
  • General Information
    • Safety Precautions
      • Fuel System
      • Ignition System
      • Test And Measuring Instruments During Test Drive
    • Clean Working Conditions
    • On Board Diagnostics
  • Description And Operation
    • Air Filter Overview
    • High Pressure Pump Overview
    • Heated Oxygen Sensors Overview
    • Fuel Injectors, Cleaning
    • Throttle Valve Control Module -J338-, CLEANING
    • Releasing Pressure In High Pressure Area
    • Engine Code CAEB
      • Component Locations Overview
      • Intake Manifold Overview
      • Fuel Rail Overview
    • Engine Code CPMA
      • Component Locations Overview
      • Intake Manifold Overview
      • Fuel Rail Overview
  • Specifications
    • Fastener Tightening Specifications
    • Technical Data
  • Diagnosis And Testing
    • Double Check-Valve, Checking
    • Fuel Holding Pressure, Checking With High Pressure Pump
    • Fuel Pressure Sensor -G247-, CHECKING
    • Vacuum System, Checking
    • Variable Intake Manifold, Checking
    • WIRING AND COMPONENTS, CHECKING WITH Test Box 105 Pin VAG 1598/42
  • Removal And Installation
    • Engine Cover
      • Removing
      • Installing
    • Air Filter
      • Removing
      • Installing
    • Air Filter Housing
      • Removing
      • Installing
    • High Pressure Pump
      • Notes
      • Removing
      • Installing
    • Fuel Injectors
    • TEFLON® Combustion Chamber Seal
    • Mass Airflow Sensor -G70-
      • Removing
      • Installing
    • Fuel Pressure Sensor -G247-
      • Notes
      • Removing
      • Installing
    • Throttle Valve Control Module -J338-
      • Removing
      • Installing
    • Heated Oxygen Sensor -G39- AND Oxygen Sensor Heater -Z19-
      • Notes
      • Removing
      • Installing
    • Oxygen Sensor after Three Way Catalytic Converter -G130- AND Heater for Oxygen Sensor 1 after Catalytic Converter -Z29-
      • Notes
      • Removing
      • Installing
    • Engine Control Module -J623-
      • Notes
      • Removing
      • Installing
    • Engine Code CAEB
      • Intake Manifold
        • Notes
        • Removing
        • Installing
      • Fuel Rail
      • EVAP Canister Purge Regulator Valve 1 -N80-
    • Engine Code CPMA
      • Cold Start Injector -N17-
        • Removing
        • Installing
      • Fuel Rail
        • Removing
        • Installing
      • Upper Intake Manifold
        • Notes
        • Removing
        • Installing
      • Lower Intake Manifold
        • Notes
        • Removing
        • Installing
      • EVAP Canister Purge Regulator Valve 1 -N80-
  • Special Tools