DTC Memory With ODIS, Checking
Warning information for the high voltage system:
Procedures for which the ignition needs to be switched on. Refer to PROCEDURES FOR WHICH THE IGNITION NEEDS TO BE SWITCHED ON .
-- Connect the Vehicle diagnostic tester. Refer to Vehicle Diagnostic Tester, CONNECTING .
-- Select Diagnosis operating mode and start diagnosis.
-- Select the VIN.
-- Set V and press Accept to select "Work with guided fault finding".
-- Continue following the program procedure.
The following describes the control module identification and forwarding to the guided fault finding.
-- Select the Control modules tab.
-- Select control modules and the Check DTC memory function by right clicking on it to see faults stored in the DTC memory.
-- Continue following the program procedure.
-- Rectify the relevant errors after discussing them with the customer.