Camshaft Position Sensor, Removing And Installing: Installing

Install in the reverse order of removal while noting the following:

• Replace the O-ring if damaged or leaking, if not available separately, then replace entire component

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

After removing or replacing the camshaft position sensor the adaptation values for the chain length must be adapted again.

-- Connect the Vehicle Diagnostic Tester .

-- Select Diagnostic  operating mode and Start diagnostics  .

-- Select the Select individual test  tab and select the following tree structure consecutively:

• Drive  (display depends on the model)
• Select the engine code and engine  (display depends on the model)
• 0001 - OBD-Capable Systems  or Diagnostic-Capable System 
• 0001 - Engine Electronics 
• 0001 - Engine electronics, functions 
• 0001 - Adaptation diagnostic chain length