LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 2018 >> S3 Prestige >> Repair and Diagnosis >> Quick Lookups >> Fluids
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Quick Lookups: Fluids

FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil 3.70 OZS. 0.1 L Approximate capacity. S
Air Cond Refrigerant w/R-1234yf 1.15 LBS. 0.52 KG R-1234yf 2018 Vehicles produced during 2017 may now be equipped with R1234yf instead of R134a. Be sure to carefully check your vehicle refrigerant and PAG oil requirements. S
Air Cond Refrigerant w/R-134a 1.05 LBS. 0.47 KG R-134a 2018 Vehicles produced during 2017 may now be equipped with R1234yf instead of R134a. Be sure to carefully check your vehicle refrigerant and PAG oil requirements. S
Automatic Transmission Fluid Initial Fill 6.70 QTS. 6.34 L VOLKSWAGEN Automatic Transmission Fluid G 052 182 A2 Part numbers are for reference only. Approximate capacity. S
Automatic Transmission Fluid Refill 6.30 QTS. 5.96 L VOLKSWAGEN Automatic Transmission Fluid G 052 182 A2 Part numbers are for reference only. Approximate capacity. S
Brake Fluid 1.10 QTS. 1.04 L Part No. B 000 750. S
Engine Coolant 10.50 QTS. 9.93 L G13 TL-VW774J Dilute with distilled water. S
Engine Oil w/Filter 6.00 QTS. 5.67 L SAE 5W-40 or 5W-30. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043 Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. S
Windshield Washer Fluid 3.20 QTS. 3.02 L Part No. 8X0 096 320 Part numbers are for reference only. Approximate capacity. S