Service Interval Display, Resetting Service Event
Risk of injury due to unintended engine start on high-voltage vehicles!
- Pay attention to the high-voltage system warning messages:
- For procedures where the ignition must be switched off. Refer to PROCEDURES THAT NEED IGNITION SWITCHED ON .
Procedure:
-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .
-- Select Diagnostic mode and start the diagnosis.
-- Perform the vehicle identification.
-- Deselect "Working with Guided Fault Finding" by removing v and pressing Accept .
-- Switch to the "Special functions" tab.
-- Service Interval, Reseting with ODIS (select the corresponding service).
-- Start the program using Perform test... .
-- Continue the program sequence.
The distance up to the current oil change service was determined by the driving profile of the customer. When the service interval display is reset, the distance to the next oil change service is recalculated based on this driving profile. Frequent cold starts or driving short distances use engine oil in significant quantities, causing the displayed distance to the next oil change service to vary based on the driving profile.