Readiness Code: Notes
When performing the Readiness drive cycle operation, pay strict attention to driving conditions and observe and obey all posted speed limits.
Readiness Code Description
Diagnostics are performed at regular intervals during normal vehicle operation. After repairing an emissions related system, a readiness code is generated by road testing the vehicle.
If a malfunction is recognized during the drive cycle, it will be stored in the DTC memory.
The OBD drive cycle operation will be monitored with a hand held diagnostic tool. Consult the manufacturer's instruction information for correct tool operation.
The readiness code is erased every time the DTC memory is erased or any time the battery is disconnected. If the DTC memory has been erased or the battery is disconnected, a new readiness code must be generated.
Only erase the DTC memory if a DTC has been stored.
General Recommendations
Most monitors will complete easier and quicker using a "steady-foot" and "smooth" acceleration during the drive cycle operation.
Operating Conditions
For the EVAP monitor test, the coolant temperature and the ambient air temperature must be between 10° C and 35° C with a difference between them no greater than 4° C. The ambient air temperature must not change more than 4° C during the drive cycle procedure (e.g. when driving out of a heated workshop in the winter).
Do not assume that the scan tool ID and engine code are correct if the scan tool communicates. The scan tool does not use the ID to establish communication-the units are automatically identified.
Test Requirements
- NO DTC in memory.
- Switch OFF all electrical and electronic accessories.
- Necessary driving speed: 50 - 70 mph.
- Drive profile takes approximately 60 - 90 min.