Assembly Mount, Checking Adjustment: Procedure

The following dimensions must be attained:

Fig 1: Identifying Distance And Dimension

Courtesy of AUDI OF AMERICA, LLC

The clearance between the engine support -2- and the engine mount -1- must be at least -a- = 10 mm.
The casting edge on the engine support must be parallel to the engine mount support arm.
Dimension -b- = dimension -b-.
Distance of at least -a- = 10 mm can also be checked with corresponding round stock.

-- If the distance measured is too small or too large, adjust the subframe. Refer to ASSEMBLY MOUNT, ADJUSTING .

-- Make sure that the edges of the support arm and the transmission mount are parallel on the transmission side.

Courtesy of AUDI OF AMERICA, LLC