Pick-Up Coil Short Check
- On Mercedes-Benz vehicles, connect one ohmmeter lead to ground. Attach other lead to control module harness terminal 3 and then to terminal 7.
- On all other models, connect one ohmmeter lead to ground. Attach other lead to terminal 7, then to terminal 31d. Resistance reading should be greater than 200, 000 ohms for Mercedes-Benz vehicles and infinity for all other models.
- If resistance reading was not correct, disconnect harness from distributor. Connect ohmmeter leads to ground and to each pick-up coil pin in distributor. If readings are now correct, replace harness. If readings are still incorrect, replace pick-up coil.