LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> BMW >> 1992 >> 325is Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Introduction
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Controls - System/Component Tests: Introduction

Before testing separate components or systems, perform procedures in BASIC TESTING article. Since many computer-controlled and monitored components set a trouble code if they malfunction, also perform procedures in G - TESTS W/ CODES article.

NOTE: System and component testing of BMW's DME/Motronic engine management system is best accomplished using the BMW MoDIC (hand-held Scan tester), BMW SERVICE TESTER (Sun 2013 Engine Analyzer) and applicable BMW diagnostic software. Tester permits technician to activate components and monitor "status" inquiries. System and component testing information is not available from manufacturer; only resistance values of individual components are included in this article. Resistance values can be measured directly on component. See PIN VOLTAGE CHART S and WIRING DIAGRAMS articles in this section for additional information.
scientia non olet · About LEMON Manuals