Coding And Programming - Overview: Progman: Administration: Settings: Network
The Network function allows network configuration information specific to the SSS to be entered, these settings should have been set during the initial installation of Progman/CIP15.0.
NOTE:
Maintain a copy of the system configuration information, in the event information gets disturbed, printout a copy and keep in a binder along with information for DISplus, GT1 and the interfaces.
Information that can be entered is similar to the information needed to configure an interface. The following information must be entered to correctly configure the SSS to the network:
- Assign a name specific to the SSS
- Gateway Address
- IP Address specific to SSS
- Information pertaining to the IP subnet mask
Any changes that are made to the configuration are saved by selecting continue and will go into effect once the SSS is restarted.
NOTE:
Restart immediately means that Progman checks the current status of any sessions that are still active and once the sessions are complete the system will restart.
Restart later indicates that Progman will wait until the end of the day (specified under "Operating Times") to check and restart the system.