Section 1848 (Integrated Suspension Systems - Repair)
WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.
- General
- 37 12 012 Carrying out ride height adjustment
- 37 00... Checking air springs for damage
- 00 Danger of poisoning if oil is ingested/absorbed through the skin
- 37 00 100 Draining/filling air spring system
- 37 00.. Notes on air spring system
- 37... Overview of 2-axle ride-height control
- 37...... Overview of Dynamic Drive (ARS)
- 37...... Overview of Vertical Dynamics Management (VDM)
- 37...... Overview of ride-height control system
- 37..... Performing vertical acceleration sensor adjustment (vertical dynamics management)
- 00..... Raising vehicle with trolley jack
- 00 Risk of injury if oil comes into contact with eyes and skin
- 00 Safety information for working on vehicles with automatic engine start-stop function (MSA)
- 00 Safety instructions for handling oil
- 37 10 001 Start-up with test run of Dynamic Drive
- Front Control And Suspension Elements
- Rear Control And Suspension Elements
- 37 12 012 Carrying out ride height adjustment
- 37 00... Checking air springs for damage
- 37 12 001 Checking function of self-levelling suspension system
- 37 12 155 Removing and installing/replacing left or right air spring
- 37 12 220 Removing and installing/replacing rear active anti-roll bar
- 37 12... Replacing lower vent line for air supply unit
- 37 12... Replacing pipes for air springs
- 37 12... Replacing upper vent line for air supply unit
- Connecting Lines
- 37 13... Notes on fitting a new pipe or a screw connection
- 37 13... Removing and installing/replacing pressure line (middle) for oscillating motor/rear axle
- 37 13... Removing and installing/replacing pressure lines (front) for oscillating motor/front axle
- 37 13... Removing and installing/replacing pressure lines (front) for oscillating motor/rear axle
- 37 13... Removing and installing/replacing pressure lines (rear) for oscillating motor/front axle
- 37 13... Removing and installing/replacing pressure lines (rear) for oscillating motor/rear axle
- 37 13 100 Removing and installing/replacing pressure lines for oscillating motor/front axle
- 37 13 110 Removing and installing/replacing pressure lines for oscillating motor/rear axle
- Electrical Components
- 37 14 610 Removing and installing / replacing lateral acceleration sensor
- 34 52 550 Removing and installing/replacing DSC rotation-rate sensor
- 37 14 055 Removing and installing/replacing DYNAMIC DRIVE control unit
- 61 36 540 Removing and installing/replacing air supply unit relay
- 37 14 525 Removing and installing/replacing control unit for air supply unit
- 37 15... Removing and installing/replacing control unit for vertical dynamics management
- 37 14 521 Replacing front left ride-height sensor
- 37 14 511 Replacing front right ride-height sensor
- 37 14 515 Replacing rear left or right ride-height sensor
- 37 10 001 Start-up with test run of Dynamic Drive
- Electronic Damping Force Adjustment
- Pump Assembly With Container