LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> BMW >> 2000 >> M5 >> Repair and Diagnosis >> Steering >> Steering Column - Repair >> Removal & Installation >> Steering Angle Sensor >> Removal & Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation

  1. Disconnect battery.
  2. Remove lower trim from instrument panel. Remove steering wheel. See STEERING WHEEL .
  3. Remove clamping bolt. Press down on steering spindle. See Fig 1.
  4. Remove steering angel sensor (1) from steering spindle. See Fig 2.
  5. To install, reverse removal procedure. Pin of pivot mounting (2) must snap into place in steering angel sensor (1). See Fig 2.
  6. Ensure clamping screw lies in locating groove in upper steering spindle. Replace self-locking nut and tighten to specification. See TORQUE SPECIFICATIONS .
Fig 1: Removing Clamping Bolt
G00175052Courtesy of BMW OF NORTH AMERICA, INC.
Fig 2: Removing Steering Angle Sensor
G00175067Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals