Rear (E65)

NOTE: A change of camber always involves a change of toe. Adjust camber first. See REAR (E65) under CAMBER ADJUSTMENT.

Replace nut (1). Ensure eccentric washer (2) is correctly located. See Fig 1. Tighten nut (1) to specification. See E65 under TORQUE SPECIFICATIONS.
Release nut (1) again by 1/2 to 1 turn.
Adjust toe with eccentric screw (3) precisely to specification. See E65 under WHEEL ALIGNMENT SPECIFICATIONS.

CAUTION: If the nut is tightened down more than 10 times during adjustment, it must be replaced again. The self-locking effect becomes too slight.

Ensure eccentric washer is correctly located (2). See Fig 1. Tighten nut (1) to specification. See E65 under TORQUE SPECIFICATIONS.

Fig 1: Locating Nut & Eccentric Washer (E65 Rear)

Courtesy of BMW OF NORTH AMERICA, INC.