Control Module Selection - Programming - Update Software: Notes

From the "Control module selection" screen specific control modules can be selected for reprogramming.

Select "Retrofits" if an accessory function/feature is to be added or deleted

Fig 1: Display Control Module Selection Screen (2 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.

Example: DME DDE is selected on the previous screen.

By selecting "Programming" the software of the selected module can be updated or a measures plan for all installed modules can be obtained and updated.

Fig 2: Selecting Programming Button

Courtesy of BMW OF NORTH AMERICA, INC.

By selecting "Update Software" a measures plan will be generated that will indicate what updates if any are available not only for the DME but for all modules installed in the vehicle.

Fig 3: Selecting Update Software Button

Courtesy of BMW OF NORTH AMERICA, INC.

A "Measures plan" provides information on updates that are available for all installed control modules. By selecting accept, all modules listed in the measures plan will be updated.

NOTE: Prior to selecting accept printout a copy of the measures plan and attach it to the repair order to document the work performed.

IMPORTANT: If the measures plan identifies any control modules that will need to be replaced exit CIP.

Fig 4: Display Select Measures Plan Table

Courtesy of BMW OF NORTH AMERICA, INC.