Steering And Wheel Alignment - Service Information

• Kinematic Diagnosis System and Environment BMW KDS (Beissbarth)
  • Notes
  • 1. Foreword
    • 1.1 Objectives
    • 1.2 Further Development of the BMW Kinematic Diagnosis System
    • 1.3 Technical Data
    • 1.4 Scope of Delivery
    • 1.5 Accessories Required
    • 1.6 Accessories Recommended
  • 2. Measuring Options Using the BMW Kinematic Diagnosis System
    • 2.1 Front Axle
    • 2.2 Rear Axle
    • 2.3 Other Measuring Options
  • 3. System Description
    • 3.1 BMW Kinematic Diagnosis System 1, Based on the Beissbarth ML4000
    • 3.2 Computer
    • 3.3 Graphical Tablet
    • 3.4 Equipment Cabinet
    • 3.5 Remote Display
    • 3.6 Measuring Sensors With CCD Camera
    • 3.7 BMW Quick-Acting Clamp
    • 3.8 Rotating/Sliding Plates
    • 3.9 Sensor Pins
    • 3.10 Spoiler Adapter
    • 3.11 Quick-Clamping Units
    • 3.12 Retainers
  • 4. Workstation
    • 4.1 Environment
    • 4.2 Preconditions For Alignment
    • 4.3 Measuring Tolerance
    • 4.4 Levelling the Measuring Station
  • 5. Chassis-Related Terms
    • 5.1 Toe-Differential Angle
    • 5.2 Camber
    • 5.3 Toe-in
    • 5.4 Castor
    • 5.5 Geometrical Drive Axis/Symmetrical Axis
    • 5.6 Wheel Displacement Angle
    • 5.7 Kingpin Offset
  • 6. Wheel Suspension
    • Notes
    • 6.1 Rigid Axle Suspension
    • 6.2 Independent Wheel Suspension
  • 7. Wheel Alignment/Procedure
    • 7.1 Measuring Options
    • 7.2 Preparatory Work
    • 7.3 Initial/Final Measurement
    • 7.4 Printing Out the Data
  • 8. Special features
    • 8.1 Free Wheel Alignment
    • 8.2 System Settings
  • 9. BMW Kinematic Diagnosis System Comparison (Bosch - Beissbarth)
  • 10. Control Modification (Menu)
    • 10.1 Remote Control With Display
    • 10.2 Brief Operating Instructions
    • 10.3 Display Support
  • 11. Updating the Software/Set Point Data
    • Notes
    • 11.1 Requirements
    • 11.2 Procedure (Beissbarth)
    • 11.3 Procedure (Bosch)
  • 12. Creating, Copying and Editing Set Point Data
    • 12.1 Copying
    • 12.2 Creating
    • 12.3 Editing
  • 13. Special Functions
    • 13.1 Customer-Specific Printer Report Header
    • 13.2 Adjusting Options
    • 13.3 Rotating Plate Test
    • 13.4 Viewing and Deleting Customer Entries From Database
  • 14. Modifications Within Program
  • 15. Faults
    • 15.1 Tire faults
    • 15.2 Front Axle Faults
    • 15.3 Rear Axle Faults