11 78 533 Replacing right control sensor (S63)
Special tools required:
- 11 7 020 .
Only perform this work after engine has cooled down.
Necessary preliminary tasks:
- Check function of DME control unit.
- Turn off ignition.
- Remove AIR FILTER HOUSING .
Unlock plug connection and detach.
Unclip control sensor cable from holder.
Release control sensor with special tool 11 7 020 .
Installation:
The threads of new lambda control/monitoring sensors are already coated with Never Seez Compound (refer to BMW Parts Department).
If a lambda control/monitoring sensor is to be reused, apply a thin and even coating of Never Seez Compound to the thread only.
The part of the lambda control/monitoring sensor which projects into the exhaust branch (sensor ceramics) must not be cleaned and not coated with lubricant.
Secure control sensor with special tool 11 7 020 and a torque wrench (1).
Tightening torque 11 78 1AZ .
Installation:
Check function of DME control unit.
Pay attention to cable routing of control sensor.