1113 Engine Oil Pan
11 13 OIL SUMP - TIGHTENING TORQUE SPECIFICATION
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Oil drain plug | S55 | M 16x1.5 (with magnesium oil sump) |
Replace screw with sealing ring. Replace sealing ring. |
20 Nm |
| M12x1.5 (with aluminium oil sump) |
Replace screw with sealing ring. Replace sealing ring. |
25 Nm | ||
| 2AZ Oil sump (magnesium) to lower section of crankcase. | S55 | M8x26 | Replace screw. Thread repairs exclusively with aluminium Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | |||
| Angle of rotation | 60° | |||
| 3AZ Oil sump (aluminium) to crankcase lower half. | S55 | M8x92 M8x112 |
Replace screw. Thread repairs exclusively with aluminium Helicoil threaded insert. Compliance with jointing torque and angle of rotation is absolutely mandatory |
|
| Jointing torque | 8 Nm | |||
| Angle of rotation | 180° | |||
| 4AZ Magnesium oil sump cover | S55 | M6x16 | Replace screw. | 8 Nm |
| 5AZ Transmission to oil sump. | S55 | M8x50 | Replace screw. Thread repairs exclusively with aluminium Helicoil threaded insert. Compliance with jointing torque and angle of rotation is absolutely mandatory |
|
| Jointing torque | 4 Nm | |||
| Angle of rotation | 100° | |||
| 6AZ Oil level sensor to oil sump. | S55 | M6 | Replace screw. Thread repairs exclusively with aluminium Helicoil threaded insert. Compliance with jointing torque and angle of rotation is absolutely mandatory |
|
| Jointing torque | 4 Nm | |||
| Angle of rotation | 100° |