Section 264 (Front Axle - Repair)
WARNING: This page is about a different car, the 2014 BMW X6 M, 2013 BMW X6 M, 2012 BMW X6 M, 2011 BMW X6 M, and 2010 BMW X6 M. However, it is still accessible from the selected car via links, so may be relevant.
- General
- 00 Danger of poisoning if oil is ingested/absorbed through the skin
- 31 00... Front axle + steering: wheel/chassis alignment check must be carried out after the following work
- 31... Front axle overview
- 31 00... Information on replacing shock absorbers
- 31 00... Instructions (chassis components made of aluminum)
- 31.... Layout of spring strut shock absorber
- 31 00 Mobile table lift
- 31 00... Notes on repairing threads
- 31.... Overview of front differential/output shafts
- 00..... Raising vehicle with trolley jack
- 00 Risk of injury if oil comes into contact with eyes and skin
- 00 Safety information for working on vehicles with automatic engine start-stop function (MSA)
- 00 Safety instructions for handling oil
- Front Axle Suspension
- Front Sub-Frame
- Struts With Rubber Mounts
- Replacing rubber mounts for front axle support in both lower wishbones
- 31 12 003 Removing and installing/replacing top right wishbone
- 31 12 004 Removing and installing/renewing left or right lower control arm
- 31 12 043 Removing and installing/replacing complete front left or right spring strut holder
- 31 12 050 Removing and installing/replacing left or right trailing link
- 31 12 002 Removing and installing/replacing top left wishbone
- 31 12 008 Replacing rubber mounts for spring strut holder in both lower wishbones
- 31 12 138 Replacing rubber mounts on both trailing links
- Wheel Bearings And Stub Axle
- Spring Strut
- Spring With Suspension
- Stabilizer Bar
- Front Axle Gearbox
- Differential With Bearings
- Output Shaft
- 31 60 ... Securing right output shaft with special tool 31 4 180
- 31 60... Notes on removing and installing Low Profile band clamps
- 31 60... Pressing output shaft out of drive flange (wheel hub) and drawing in
- 31 60 003 Removing and installing/replacing left output shaft
- 31 60 004 Removing and installing/replacing right output shaft
- 31 60 530 Replacing an output shaft gaiter (on transmission side) (output shaft removed)
- 31 51 015 Replacing shaft seal for left output shaft
- 31 51 020 Replacing shaft seal for right output shaft
- 31 60 535 Replacing two gaiters on output shaft(s) (output shaft(s) removed)