Chart C2B - Idle Air Control (3.3L): Notes

The "Scan" tester will read the ECM commands to the IAC valve in counts (0-255). The greater the counts, the more air allowed (higher idle). The less the counts, the less air allowed (lower idle).

1. Continue with test, even if engine will not idle. If idle is too low, "Scan" tester will display 80 or more counts, or steps. If idle is high, it will display zero counts. Occasionally an erratic or unstable idle may occur. If engine speed varies 200 RPM or more up and down, disconnect IAC. If the condition is unchanged, the IAC is not at fault.
2. When the engine was stopped, the IAC valve retracted (more air) to a fixed "Park" position for increased airflow and idle speed during the next engine start. A "Scan" tester will display 100 or more counts.
3. Be sure to disconnect the IAC valve prior to this test. The test light will confirm the ECM signals by a steady or flashing light on all circuits.
4. There is a remote possibility that one of the circuits is shorted to voltage, which would have been indicated by a steady light. Turn ignition off and disconnect ECM. Turn the ignition on and probe terminals to check for this condition.