Circuit Description

When engine is cranking, Ignition Control Module (ICM) sends a spark reference and a fuel control signal to PCM. At start of crank, ICM controls ignition timing (module mode). PCM sends a 5-volt signal on by-pass circuit to switch timing to PCM control when second fuel control pulse is recognized by PCM. Code P1350 will set at start-up if an open is present in ignition control circuit. Code P1361 will set if an open in Ignition Control (IC) circuit, or an open or grounded by-pass circuit is present during time when engine is started. Engine may be started but will run on module mode timing.