Fuel Injector(s)

Disconnect fuel injector harness connector. Measure resistance across injector terminals at each injector. Resistance should be as specified. See INJECTOR RESISTANCE SPECIFICATIONS .

INJECTOR RESISTANCE SPECIFICATIONS ⁽¹⁾

Application

Ohms

3.8L ⁽²⁾

VIN L

With Bosch Injector

14.3-14.7

Without Bosch Injector

11.8-12.6

VIN I

14.3-14.7

⁽¹⁾	Injector resistance specification is at 140°F (60°C).

⁽²⁾	The Injector Resistance Specifications has been updated by TSB Bulletin No. 61-63-08, dated June 1996.

NOTE: If injectors are dirty, they should be cleaned using approved injector cleaning procedure before performing INJECTOR BALANCE TEST.