With Scan Tool (Century, Intrigue & Regal)
- Turn ignition switch to OFF position. Connect scan tool to Data Link Connector (DLC). DLC is located below left side of instrument panel, to right of steering column. See Figure . Turn ignition switch to RUN position.
- Using scan tool, select BODY CONTROL MODULE SPECIAL FUNCTION, then PROGRAM KEY FOBS. Press and hold LOCK button and UNLOCK button simultaneously on one transmitter. After a delay of 15 seconds, horn will chirp 3 times to confirm programming of that transmitter. Follow directions on scan tool to program other transmitters.
- Turn ignition switch to OFF position. Remove scan tool. Operate transmitter(s) to verify correct system operation.
NOTE:
Scan tool must stay connected until all transmitters are programmed.