Scan Tool Data Definitions

Battery Voltage:  The scan tool displays Volts. The scan tool displays the battery voltage received by the module.

Crank:  The scan tool displays Yes/No. The scan tool displays yes when the module receives battery positive voltage on the crank request signal circuit.

Crank Request Signal:  The scan tool displays Yes/No. The scan tool displays No until the ignition is placed into the START position then Yes is displayed.

GEN F-Terminal Signal:  The scan tool displays 0-100%. The scan tool displays 0-10% until the engine is started and the PCM receives a signal from the generator then OK is displayed.

GEN L-Terminal Signal Command:  The scan tool displays On/Off. The scan tool displays Off until the engine is running, then the PCM supplies then the percentage value varies depending on electrical loads.

Ignition 1 Signal:  The scan tool displays 0-20 Volts. The scan tool displays the voltage as received on the Ignition 1 circuit to the PCM.

Starter Enable Relay Circuit Status:  The scan tool displays Fault/OK/Invalid State. The scan tool displays Fault until the ignition is placed into the START position then OK is displayed.

Starter Relay Command:  The scan tool displays ON/OFF. The scan tool displays Off until the ignition is placed into the CRANK position, then it reads On.

Volt Lamp:  The scan tool displays On/Off. The scan too displays On when the module commands the volts lamp to be ON.