Removal & Installation: Notes
WARNING:
Deactivate air bag system before performing any service operation. See AIR BAG DEACTIVATION PROCEDURES
under RESTRAINTS in GENERAL INFORMATION article. DO NOT apply electrical power to any component on steering column without first deactivating air bag system. Air bag may deploy.
CAUTION:
When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES
article in GENERAL INFORMATION before disconnecting battery.
NOTE:
Vehicles are designed for starter mounting without shims. A single shim or double shims may have been added to correct a noise or engagement condition. Clearance shims .039" (1.0 mm) thick are available in 3 different shapes. When installing starter, any previously installed shims should be replaced in original location to ensure proper pinion to flywheel clearance.
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. DO NOT use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.