Installation Procedure

IMPORTANT: The throttle should operate freely without binding between a full closed and a wide open throttle.

Fig 1: Locating Accelerator Pedal Components

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the accelerator pedal bolt (3) and the stud (2).
Tighten: Tighten the bolt and the stud to 5 N.m (44 lb in).
Install the accelerator cable (5) to the accelerator pedal (1).
Inspect for complete throttle opening and closing positions by operating the accelerator pedal. Also inspect for poor carpet fit under the accelerator pedal.
Install the left instrument panel sound insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.