LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2004 >> Regal GS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls 3.8L (Introduction, Service & Replacement) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Fuel Pump & Sender Assembly Component View
    GM50636Courtesy of GENERAL MOTORS CORP.
  1. Install the new fuel tank pressure sensor (7) to the fuel sender assembly.
  2. Connect the fuel tank pressure electrical connector.
    3. Fig 2: View Of Fuel Sender Access Panel
    GM65739Courtesy of GENERAL MOTORS CORP.
  3. Install the fuel sender access panel.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the fuel sender access panel retaining nuts.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  5. Install the rear compartment trim panel. Refer to Compartment Trim Panel Replacement - Rear in Body Rear End.
scientia non olet · About LEMON Manuals