Installation Procedure

NOTE: Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be securely fastened. This is necessary in order to prevent possible interference and damage to the component.

Fig 1: View Of Accelerator Controls Cable Bracket

Courtesy of GENERAL MOTORS CORP.

Install the bracket to the throttle body.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 2 accelerator cable bracket bolts.
Tighten: Tighten the bolts to 10 N.m (89 lb in).

Fig 2: View Of Accelerator Cable At Throttle Body

Courtesy of GENERAL MOTORS CORP.

Install the accelerator cable (2) to the bracket (1).
Install the accelerator cable to the throttle body.

Fig 3: View Of Cruise Control Cable

Courtesy of GENERAL MOTORS CORP.

Install the cruise control cable (1) to the bracket (2).
Install the cruise control cable to the throttle body.

IMPORTANT: The throttle should operate freely, without binding, between full closed and wide open throttle.

Inspect for complete throttle opening and closing positions by operating the accelerator pedal.
Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L36) or Fuel Injector Sight Shield Replacement (L67) in Engine Mechanical - 3.8L.