LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2004 >> Regal LS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls 3.8L (Introduction, Service & Replacement) >> Repair Instructions >> Throttle Body Assembly Replacement (L67) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Throttle Body Assembly
    GM12267Courtesy of GENERAL MOTORS CORP.
  1. Install the new gasket.
  2. Install the throttle body assembly.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the throttle body nuts.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  4. Install the accelerator controls cable bracket. Refer to Accelerator Controls Cable Bracket Replacement .
    5. Fig 2: View Of Vacuum Hoses To Throttle Body
    GM180061Courtesy of GENERAL MOTORS CORP.
  5. Install the vacuum line to the throttle body.
    6. Fig 3: View Of IAC Valve Electrical Connector
    GM155466Courtesy of GENERAL MOTORS CORP.
  6. Connect the IAC valve sensor electrical connector.
    7. Fig 4: View Of MAF Sensor & Electrical Connector
    GM155464Courtesy of GENERAL MOTORS CORP.
  7. Connect the MAF sensor electrical connector.
    8. Fig 5: View Of TP Sensor & Connector
    GM178680Courtesy of GENERAL MOTORS CORP.
  8. Connect the TP sensor electrical connector.
  9. Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
  10. Fill the cooling system. Refer toDraining and Filling Cooling System in Engine Cooling.
  11. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L36) or Fuel Injector Sight Shield Replacement (L67) in Engine Mechanical - 3.8L.
scientia non olet · About LEMON Manuals