Installation Procedure
- Install the PCM to the connectors.
Tighten: Tighten the connectors to 8 N.m (71 lb in).
- Install the PCM (4) and the harness into the air cleaner housing.
- Install the air cleaner housing cover assembly. Refer to Air Cleaner Assembly Replacement .
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
- The new PCM must be programmed. Refer to Control Module References in Computer/Integrating Systems.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.