LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 3.8L - Introduction >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement (NT7) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Identifying Fuel Level Sensor Wiring Harness Electrical Connector
    GM1671971Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel tank pressure sensor.
  2. Connect the fuel level sensor wiring harness electrical connector (1) to the fuel tank pressure sensor.
    3. Fig 2: Identifying Fuel Sender Access Hole Cover
    GM1671970Courtesy of GENERAL MOTORS CORP.
  3. Place the fuel sender access hole cover into position.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the fuel sender access hole cover bolts.

    Tighten:  Tighten the bolts to 2 N.m (18 lb in).

  5. Install the rear compartment liner. Refer to REAR COMPARTMENT TRIM PANEL REPLACEMENT .
scientia non olet · About LEMON Manuals