Installation Procedure

CAUTION: Refer to Fastener Caution .

Install the PCM to the PCM electrical connectors (4).
Tighten: Tighten the connectors to 8 N.m (71 lb in).
Install the PCM and the wiring harness to the air cleaner housing assembly (3).

Fig 1: View Of Air Cleaner Housing, Bolts, PCM & Harness

Courtesy of GENERAL MOTORS CORP.

Install the air cleaner housing cover (1).
Install the air cleaner housing cover screws (2).
Tighten: Tighten the screws to 4 N.m (35 lb in).
Install the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement .
Install the left front inner fender brace. Refer to FRONT FENDER UPPER DIAGONAL BRACE REPLACEMENT .
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (L26) .
The new PCM must be programmed. Refer to Control Module References .