Removal Procedure
- Relieve the fuel system pressure. Refer to Fuel Pressure Relief .
- Blow dirt out of the fitting using compressed air.
- Squeeze the plastic tabs of the male end connector.
- Pull the connection apart.
- Wipe off the male pipe end using a clean shop towel.
- Inspect both ends of the fitting for dirt and burrs.
- Clean or replace the components as required.
WARNING:
Wear safety glasses when using compressed air in order to prevent eye injury.
CAUTION:
Use an emery cloth in order to remove rust or burrs from the fuel pipe. Use a radial motion with the fuel pipe end in order to prevent damage to the O-ring sealing surface.