Keyless Entry Control Module Replacement

WARNING: This page is about a different car, the 2011 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Keyless Entry Control Module

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection . Remove the instrument panel compartment. Refer to Instrument Panel Compartment Replacement .
1	Wiring Harness Bracket Procedure: Release the wiring harness bracket.
2	Keyless Entry Control Module Procedure Disconnect the wiring harness connectors. Clip out the fixing points from the keyless entry control module. Remove the keyless entry control module. After repairs, for programming and set up information. Refer to Control Module References .

Callout

Component Name

Preliminary Procedures

Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
Remove the instrument panel compartment. Refer to Instrument Panel Compartment Replacement .

Wiring Harness Bracket
Procedure:
Release the wiring harness bracket.

Keyless Entry Control Module

Procedure

Disconnect the wiring harness connectors.
Clip out the fixing points from the keyless entry control module.
Remove the keyless entry control module.
After repairs, for programming and set up information. Refer to Control Module References .