Circuit/System Verification
NOTE:
Diagnose all other stop lamp DTCs or Symptoms prior to performing this diagnostic procedure.
DTC C0131 4B
- Ignition ON.
- Verify that DTC C0131 4B is not set.
- If the DTC is set
- Perform the Brake Pressure Modulator Valve Pressure Sensor Calibration .
- Verify the DTC does not set.
- If the DTC sets, replace the Q5 brake pressure modulator.
- If the DTC does not set.
- All OK.
- If The DTC is not set
- All OK.
DTC C0131 00 or C0131 5A
- Ignition ON.
- Verify that DTCs C0131 00 or C0131 5A are not set.
- If either DTC is set
- Replace the Q5 brake pressure modulator.
- Ignition ON.
- Verify the DTC does not set.
- If the DTC sets, replace the K17 electronic brake control module.
- If the DTC does not set.
- All OK.
- If the DTCs are not set
- All OK.