LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2013 >> Encore Base, AWD >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Fluid Cooler Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Power Steering Fluid Cooler
    GM2812359Courtesy of GENERAL MOTORS COMPANY
  1. Position the power steering fluid cooler (2) on the vehicle.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the power steering fluid cooler nuts (1) and tighten to 9 N.m (80 lb in).
    3. Fig 2: P/S Fluid Reservoir Inlet Pipe
    GM2810052Courtesy of GENERAL MOTORS COMPANY
  3. Connect the power steering fluid reservoir inlet pipe (2) to the power steering fluid cooler and secure with the power steering fluid reservoir inlet pipe clamp (1).
  4. Connect the power steering gear outlet hose to the power steering fluid cooler (2) and secure with the power steering gear outlet hose clamp (1).
    5. Fig 3: Power Steering Gear Outlet Hose And Clamp
    GM2812352Courtesy of GENERAL MOTORS COMPANY
  5. Secure the power steering fluid cooler bracket with the plastic push pin (3).
  6. Clean any excess power steering fluid from the vehicle and remove the drain pans.
  7. Install the front bumper fascia. Refer to Front Bumper Fascia Replacement (Buick) .
  8. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals