Installation Procedure
- In case of reuse of the exhaust parts, check the exhaust pipes at the separating sets for the following conditions:
- Roundness of the exhaust pipe, any deformation in the range of the double-clamp must be eliminated.
- Burrs inside and outside the exhaust pipe at the cutting edge, use a file to eliminate.
- Rust at the exhaust pipe outside, use a sandpaper to eliminate.
- Install the exhaust muffler (2) with a NEW gasket (3) to the catalytic converter.
- Support the exhaust muffler.
- Install the 2 nuts (4) and tighten to 17 N.m (13 lb ft).
- Install the exhaust pipe clamp (1) and loosely tighten.
- Position the exhaust rear muffler and the exhaust rear auxiliary muffler.
- Tighten the exhaust pipe clamp (1) to 30 N.m (22 lb ft).
- Lower and unsupport the vehicle.
NOTE:
A second technician is required.
CAUTION:
Refer to Fastener Caution .